OPERATION
10
Speed Scrub 2401/2601 (04--05)
7. Align pad driver mounting studs with slots in motor
hub. Give the driver a quick turn toward the motor
hub spring clip. Be certain that spring clip locks
into one of the studs before operating machine
(Figure 9).
FIG. 9
NOTE:
Always make sure pad drivers and motor hub
surfaces are always clean before installing drivers.
Clean surfaces will ease pad driver removal later.
8. Close skirt housing and refasten latch.
INSTALLING FaST--PAK AGENT (OPTION)
Machine must be equipped with the FaST Option.
1. Remove the perforated knock-outs from the
FaST--PAK MP (Multi-purpose) Hard Floor
Concentrate carton. Do not remove the bag from
the carton. Pull out the bag’s hose connector at
the bottom of the bag and remove the orange
hose cap from the connector (Figure 10).
ATTENTION: The FaST--PAK MP Hard Floor
Concentrate is specifically designed for the FaST
system scrubbing application. NEVER use a
substitute, machine damage will result.
FOR SAFETY: When using machine, always follow
the handling instructions on chemical container.
FIG. 10
2. Place the FaST--PAK carton in the carton holder at
the rear of the machine and connect the supply
hose to the FaST--PAK bag (Figure 11).
FIG. 11
NOTE:
If any dried concentrate is visible on the supply
hose connector or on the FaST--PAK connector, soak
and clean with warm water.
3. Make sure to connect the supply hose onto the
hose storing plug when not in use (Figure 12).
This will prevent the FaST solution system from
drying out and clogging up the supply hose.
FIG. 12
4. The FaST solution system MUST be primed for
first time use. To prime system, make sure the
solution tank is empty and operate the machine in
the FaST Scrub Mode for 3 minutes (See
MACHINE OPERATION).
This step is only
required for first time FaST system use.
