OPERATION
6
Speed Scrub 1701/2001/2400 (11--97)
WARNING: Do not drop batteries into
compartment! Battery and machine housing
damage may result. This damage is not covered
by warranty.
4. To secure batteries, place white PVC tube spacer
‘‘A” behind batteries in compartment as shown.
5. Connect cables to battery posts in numerical order
as labeled (RED TO POSITIVE & BLACK TO
NEGATIVE)
(Figure 3.).
6. Double check cable connections before closing up
battery compartment.
MACHINE SET UP
PRE--OPERATION CHECKS
1. Sweep the floor to remove particles and other
debris.
2. Check battery meter charge level to ensure
batteries are fully charged if applicable. (See
BATTERY CHARGING)
3. Check that a pad(s) or brush(es) are installed.
4. Check that squeegee is installed.
INSTALLING BRUSH OR PAD DRIVER
FOR SAFETY: To prevent accidental starting, pull
out circuit breaker button before installing brush
or pad driver. Circuit breaker button is located at
rear of control housing.
1. Lower brush head, step down firmly on top pedal
and push pedal forward
(Figure 4).
FIG. 4
2. Position squeegee swivel mechanism so it’s
centered behind machine.
3. Tilt machine back on squeegee to access motor
hub for pad driver/brush installation.
WARNING: Do not leave machine tilted back
for an extended time. Battery acid may run out the
top of batteries. Battery acid can cause severe
burns on contact with skin. Also, squeegee blades
may damage if left tilted back.
4. Select recommended pad or brush that best
meets your cleaning needs.
IMPORTANT: Consult your authorized distributor
to assist you in choosing the correct pad or brush
for your specific cleaning need.
5.
(For Pad Installation)
Attach pad to pad driver.
Attach pad before installing pad driver to motor
hub: Remove plastic centerlock from pad driver.
Position pad centered on pad driver and replace
centerlock securely
(Figure 5).
FIG. 5
6. Attach brush or pad driver to motor hub. Align 3
mounting studs with slots in motor hub. Give the
driver a quick turn toward the spring clip on the
motor hub. Be certain pad driver is securely
fastened and spring clip locks into one of the studs
on the driver before operating machine
(Figure 6).
FIG. 6
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
