OPERATION
Speed Scrub 1701/2001/2400 (11--97)
7
7. Raise brush head. To raise brush head, step
down firmly on the bottom brush lift foot pedal until
brush locks into the raised position
(Figure 7).
FIG. 7
FILLING SOLUTION TANK
1. Push machine to fill station. Raise squeegee and
brush when transporting.
2. Shut off solution flow, pull back completely on
solution flow lever
(Figure 8).
FIG. 8
3. Open solution fill door at front of machine and fill
solution tank with up to 10 gallons (37.8 liters) of
water (140
_
F, 60
_
C maximum temperature). Clear
tub at rear of machine has 5 and 10 gallon
markers to indicate amount of water poured into
tank
(Figure 9).
FIG. 9
NOTE:
If filling with a bucket be certain that bucket is
clean. This will prevent the chance of clogging the
solution lines.
4. Add cleaning chemicals to the proper dilution ratio
according to the bottles instructions.
CAUTION: Use only recommended cleaning
chemicals, DO NOT use substitutes. Consult
authorized distributor to assist you with the
recommended cleaning chemicals.
WARNING: Use only nonflammable
commercial cleaning chemicals.
PLUGGING POWER CORD INTO A GROUNDED
WALL OUTLET (
Electric Models Only
)
Connect 75” extension cord to machine pigtail and
plug cord into a grounded outlet
(Figure 10).
Grounded
Grounding
Edge/hole
Grounded
3 Hole Outlet
Ground Pin
(120V)
(230V)
Outlet
FIG. 10
WARNING: To avoid serious personal injury,
plug power cord into grounded outlets only. Do
not use an adapter or remove ground pin on plug.
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
