Noblelift PT 20I, Instruction Handbook Manual

Page: 15 / 32

14
e.
Travelling
TRAVEL ON SLOPE ONLY WITH THE LOAD FACING UPHILL
.
DO NOT TRAVEL ON SLOPE WHEN EXCEEDING THE SPECIFIED TECHNICAL
DATA.
WHEN TRUCK IS USED ANLY AS STACKER, TRAVELLING IS ONLY ALLOWED IF
THE FORKS ARE LOWERED DOWN TO THE LIFTING POINT (<500MM). WHEN
LIFTING HEIGHT IS HEIGHER THAN 500MM, TRAVELLING SPEED IS 2.5km/h,
ACCELERATION WILL DECREASE.
WHEN TRUCK IS USED AS PALLET TRUCK AND STACKER AN THE SAME TIME,
LOWER THE TOP FORK AS LOWER AS POSSIBLE, BUT DO NOT TOUCH THE
LOAD ON THE BOTTOM FORK.
After starting the truck by turning on the key switch (6), move the tiller to the operating zone (‘F’, fig.10).
Turn the accelerator button to the desired direction forward ‘Fw.’ or backwards Bw.’(fig. 10).
Control the travelling speed by moving the accelerator button (17) carefully until reaching the desired
speed.
If you move the accelerator button back to the neutral position, the controller decelerates the truck until it
stops. If the truck stopped, the parking brake will be engaged.
Drive the truck carefully to the destination. Watch the route conditions and adjust the travelling speed
with the accelerator-button.
f.
Steering
Make the truck turn by moving the tiller to the left or right side.
Fig. 10: Operating direction