Use and maintenance manual - Model: “UNICA 10 V/C”
15
ENGLISH
7.2 KEYS
The handheld device is presented as in the image
below:
1
Increase key (selection key)
2
Decrease key (selection key)
3
ON/OFF or reset from “Sleep” mode key
4
Display
5
MENU access and confirm key
6
Back to previous screen key
In “Sleep” mode, the screen of the handheld
device is blacked out, only maintaining enabled, if
necessary, the remote communication with the
appliance, to reduce battery consumption.
7.3 DISPLAY
The handheld device display is as follows:
After 20 seconds of inactivity, the display on the
handheld device blacks out and passes to “SLEEP”
mode, maintaining the remote connection with the
appliance. The display re-enables only by pressing
the
key.
STAND-BY SCREEN
Before connection using the emergency cable,
remove the batteries from the handheld device
from the specific compartment. DANGER OF FIRE
1
2
3
4
5
6
1
2
3
7
DESCRIPTION OF THE REMOTE CONTROL
Before switching on the appliance, you are advised
to read the following chapter carefully relating to
use of the receiver and the handheld device, as well
as their related functions.
INFORMATIVE NOTE:
• frequency bands and transmitted power used by the
equipment as reported in technical documentation:
868.3MHz - 869.85MHz
• frequency bands and respective power limits
transmitted applicable to the device (frequencies
and standardized powers): 6dBm ERP.
7.1 RECEIVER
The appliance is equipped with an emergency
remote board, placed at the back of it, which allows
basic management of the functions in the event the
handheld device is faulty or not working properly.
1
Serial connection (use by authorised staff ONLY)
2
USB connection (use by authorised staff ONLY)
3
Emergency cable connection
4
GREEN LED - appliance working status
5
YELLOW LED - remote communication in progress
6
RED LED - alarm on
7
BLUE LED - System updating in progress
8
Appliance switch on/off button
9
Receiver handheld device remote combination
button
10
Manual upgrade button
(use by authorised staff ONLY)
In the event of malfunctioning of the remote
communication between the handheld device
and the receiver, or if the batteries are flat,
use the
emergency cable
supplied, to restore
communication between the remote devices.
1
3
2
4 5
6 7
8
9
10
EMERGENCY
CABLE
CONNECTION
3
Summary of Contents for UNICA 10 C
Page 1: ...EN Installation use and maintenance manual UNICA 10 V C...
Page 37: ...Use and maintenance manual Model UNICA 10 V C 37 ENGLISH ANNOTATIONS...
Page 38: ...Use and maintenance manual Model UNICA 10 V C 38 ENGLISH ANNOTATIONS...
Page 39: ...Use and maintenance manual Model UNICA 10 V C 39 ENGLISH ANNOTATIONS...
