Nobis B10 V ULISSE, Instructions For Installation, Use And Maintenance Manual

Page: 29 / 40

Use and Maintenance Manual model “B10 V ULISSE”
29
ENGLISH ENGLISH
13 PHASES OVERVIEW
PHASE DESCRIPTION
- The resistor start pre-heating and
pellets begin to fall in the brazier.
- Pellet ignites thanks to the heat
generated by the inlet air flow -
ing through the duct of the
incandescent resistor.
- Pellet loading restarts and the
flame develops.
The appliance has carried out the
switch-on phase and starts operating
at due power as per settings.
Desired room temperature has been
reached.
The cleaning phase of the brazier is
enabled without movement of the
cleaner (periodic function).
The brazier-cleaning phase is run-
ning with the cleaner enabled. The
appliance will switch off and back
on automatically.
Restart is required after cooling.
Once done, the appliance will start
working automatically.
The appliance is switching off and
cooling has not finished yet.
The appliance is OFF and all motors
are disabled.
SWITCH ON
WORK
SAVING
BRAZIER CLEANING
CLEANER ENABLED
FINAL CLEANING
OFF
WAITING FLAME
FLAME PHASE
RESTART
PHASE DESCRIPTION
Room setting on MAN. The appli-
ance will only work with the power
set for the fireplace (it never switch -
es to savng mode).
MAN WORK
14 FUNCTIONS OVERVIEW
Edit the data highlighted using the keys
Confirm the change by using
Repeat the same operation to set the next parameter;
OK
12.6 DISPLAYING CANALIZATION STATUS
To display the canalization status, from the STAND-BY
screen, press .
The display screen will appear as follows:
SET RIGHT
CANALIZED
ENVIRONMENT
TEMP. RIGHT
CANALIZED
ENVIRONMENT
RIGHT VENTILATION
SPEED
When POWERFUL function is enabled, canalization
will also be visible in this function, as in the figure
above.
After confirming settings for RIGHT canalization,
press and then repeat the same procedure for
LEFT canalization.
OK
Edit highlighted data using the keys
Confirm the change using
Repeat the same operation to set the next parameter;
To confirm all settings and return to the STAND-BY
screen, press .
OK
OK
SET LEFT
CANALIZED
ENVIRONMENT
LEFT CANALIZED
ENV. TEMP.
LEFT VENTILATION
SPEED
When room temperature for canalization has been
set, this will only be managed if the TEMPERATURE
CONTROL function is enabled, as previously seen,
and ENABLE EXT T. (in SETTINGS section of the
CANALIZATION menu) disabled.