-8-
25. Bolt the
Knee Roller Support
(12) to the
Main Upright
(3) using bolting shown.
26. Bolt the
Back Pad
(28) to the
Main Upright
using bolting shown.
27. Bolt the
Seat Pad
(29) to the
Seat Support
(10) bolting shown. Install 2 -
1" x 2" Plastic Caps
(AD).
Insert
Seat Support
into the
Lower Frame
where shown. Vertically locate the
Seat Support
and hold
in position with the Clamping Pin located on the opposite side.
28. Insert the
Leg Extension Roller Tube
(15) into the
Leg Extension
where shown and install 2-
Foam
Rollers
(30) along with 2 -
Foam Roller Caps
(AG).
29. Install remaining four
Foam Rollers
and four
Foam Roller Caps
where shown.
30. Attach four
Cable Handle Nylon
(22) to the snap hooks on the ends of
Press Arm Cable
and
Lat
Cable
.
NOTE: Make certain that all cables have been properly positioned on/around pulleys before use
and that all nuts have been tightened.
22
4 Places
29
30
28
AD
AD
10
H
J
15
Where Shown
6 Places
6 Places
P
E
AG
12
6 Places
B
3
Cables are a consumable and must be treated as such. As a minimum, an annual inspection must
be performed on all cable ends and full lengths. A cable must be replaced immediately if broken
exposed wires and/or a break in cable coating are found.
C
