NKT Photonics Koheras ADJUSTIK, Product Manual

Page: 29 / 105

29
Status LEDs
Status LEDs
The front panel houses four status LEDs as described in
Table 5
. The LEDs are
located on the front panel as shown in
Figure 1
.
Table 5 Status LEDs
Note: D
O NOT OPERATE
the laser until you are familiar with the controls and have taken
all precautions necessary as described in the document: Koheras ADJUSTIK Safety,
Handling and Regulatory Information .
LED Name Condition Description
Power ON Green AC mains connected and power switch is in the ON position.
ON Red Fault with the DC power supply
OFF System switched off or no AC mains power
Status OFF One of the following:
•
Interlock is reset but there is no emission from the system
•
Alternatively firmware is being uploaded to the system main
control board. During firmware upgrade the interlock
cannot be reset and no emission from the system is possible.
ON Orange Interlock fault or the interlock needs to be reset.
Flashing Orange The system main control board is scanning for modules
attached to the system and accessories connected to the
external bus.
ON Green Laser emission enabled and the system is stabilized.
Flashing Green Laser emission enabled but the system has not stabilized.
ON Red Either one or multiple modules in the system or connected
to the External Bus have shut down.
Flashing Red Firmware is being uploaded to modules in the Koheras
ADJUSTIK system or accessories connected to the External
Bus.
Emission ON Red Laser emission is ON.
OFF Laser emission is OFF.