Nivus NivuLog Easy V3, User Manual

Page: 90 / 141

Mode
Basic setting for the output channel
Note: Note that the power consumption increases significantly when "Freq" mode is activated.
When using a rechargeable battery pack (e.g. Rechargeable battery pack for NivuLog Easy V3
) the running time to be reached might thus be reduced to 1/6.
Off --- Output channel deactivated
Ext. warmup
time The output channel is switched on "Ext. warmup time" seconds prior to the
measurement. If the value is "0", the output channel is not switched on at all.
Voltage
1)
Selection of the output voltage
Digital Invert Inverts the level issued on the device
Voltage
1)
Selection of the output voltage
Setpoint Setpoint (on/off) that should be issued
GPS
2)
Reserved for extensions
Freq
3)
Factor The setpoint multiplied by the factor equals the frequency in Hertz.
The result of the multiplication must not exceed 1000 Hz.
Setpoint The setpoint multiplied by the factor equals the frequency in Hertz.
The result of the multiplication must not exceed 1000 Hz.
Pulse
3)
Factor The setpoint multiplied by the factor equals the pulse/min. The result
of the multiplication must not exceed 320 pulses/min.
Setpoint The setpoint multiplied by the factor equals the pulse/min. The result
of the multiplication must not exceed 320 pulses/min.
1)
Selection of the output voltage is only possible for the switchable sensor supply VOUT.
2)
This mode is only available for switchable sensor supply output VEXT.
3)
These modes are only available for the isolated switch contact (NO, CC).
Note:
Additional explanation on "Digital" mode
Invert Setpoint Output on the device
Off Off = Off (low)
Off On = On (high)
On Off = On (high)
On On = Off (low)
90 of 141 NivuLog Easy V3 - Rev. 03 as of 24.10.2018