5
3-3. Lubrication
Install an oiler between the compressor and the tool.
Use the machine oil ISO VG-10. Failure to lubricate
as required may result in damage to the tool. Use of
oil that is too thick will reduce the performance of the
tool.
4. OPERATION
4-1. How to replace tip tool
(Fig. 2)
Warning
●
Turn off the Valve and disconnect the air hose
before replacing tip tool.
Insert the file shaft into the holder and tighten a
Hexagon Socket Head Locking Screw with a Hex.
Wrench Key 2 attached. To remove tip tool shaft,
loosen the Hexagon Socket Head Locking Screw
with the Hex. Wrench Key 2 and remove tip tool.
Loosen
Sleeve
Φ
3
Tip tool
Tighten
Hex. Socket Screw Key 2
Fig. 2
4-2. Start and Stop
Make sure the Valve is turned off before inserting
the air hose into the Cupla of the this tool.
Start: Sliding the Valve to the Housing side starts the
tool. (Valve ON)
Stop: Sliding the Valve from the housing side to the
Exhaust Hose side stops the tool. (Valve OFF)
ON-OFF Display
Valve
ON
OFF
Fig. 3
4-3. Grinding and polishing operations
Warning
●
Be sure to wear protective glasses and a
dustproof mask during operation.
Start the tool, lightly press the File against the work,
and carry out the operation. Applying unnecessarily
strong force to the File does not improve the work
efficiency.
In addition, unnecessary force applied to tip tool
may cause breakage of the electro-plated tip tools.
4-4. Storing Tool
Warning
●
When tool is not used, store it out of reach of
children.
When the tool is not used, store it in a dry area.
If the tool is left alone as it has been used without
preparation for storage, ambient moisture will remain
inside the tool, which will leave it susceptible to
rusting. After finishing your work, add the machine
oil #10 through the Air Hose and run the tool for a
while before storage.
5. OPTIONAL PARTS
In addition to standard accessory parts, the following
parts are available for your applications and needs.
Part No.
Part name
Q’ty
TB07502 Flat Electro-Plated File #140
1set (5 pcs.)
TB07503 Rat-Tail Electro-Plated File #140
1set (5 pcs.)
TB07504 Triangular Electro-Plated File #140
1set (5 pcs.)
TB07505 Half-Round Electro-Plated File #140 1set (5 pcs.)
TB07506 Vise Holder 3
1set
6. ORDERING PARTS
When ordering parts from our agency, please be
sure to give them part number, part name and
quantities.
