4
INSTRUCTIONS FOR
THIS TOOL
Warning
●
Wear protective glasses and a dustproof mask
Operation generates chips and dust particles, etc.
which may cause eye and/or respiratory injury:
Always use PPE (Personal Protective Equipment)
for eye and respiratory protection.
Caution
●
Insert tip tool shaft of tip tool into the holder as
deep as possible before using the tool.
Imperfect imsertion of the file shaft of tip tool not
only damages the main body but also causes tip tool
to jump out and may cause accidents.
●
Do not use tip tool with tip tool shaft other than
3 mm.
The use of tip tool with a file shaft other than 3 mm
may damage the main body, cause tip tool to jump
out, and result in accidents.
●
When you replace or adjust tip tool or any
component, be sure to detach the tool from the
air hose.
●
N e v e r t o u c h t i p m o b i l e p o r t i o n w h i l e i n
operation.
1. APPLICATION
This tool is a pneumatic lapping tool to carry out
grinding operations using an Electro-Plated Diamond
File, and grinding and polishing operations using Oil
Stone and Fiber Grindstone, etc.
2. RECEIVING INSPECTION
Upon unpacking, check to see that the shipment is
complete without damage or oil leakage in transport.
Should you find any damage or short-shipment,
please contact sales agent through which you have
purchased your machine or an authorized dealer near
you for corrective actions.
MAH-05
Package Contents
Q’ty
MICRO AIR HAND MAH-05
1set
Flat Electro-Plated File #140
1
Rat-Tail Electro-Plated File #140
1
Hex. Socket Screw Key 2
1
Bushing R1/4xNPT1/4
1
Instruction Manual
1
Attention for Start-up MAH-05/MAH-16
1
Caution for Use
1
Declaration of Conformity
1
MAH-16
Package Contents
Q’ty
MICRO AIR HAND MAH-16
1set
Flat Electro-Plated File #140
1
Rat-Tail Electro-Plated File #140
1
Hex. Socket Screw Key 2
1
Bushing R1/4xNPT1/4
1
Instruction Manual
1
Attention for Start-up MAH-05/MAH-16
1
Caution for Use
1
Declaration of Conformity
1
3. AIR SUPPLY
3-1. Air Pressure
Adjust air pressure with the air regulator to the
appropriate level for the pneumatic tool used.
Air pressure that is too low will stop the tool from
operating at full capacity.
Air pressure that is too high may cause damage to
the tool.
3-2. Air Line
(Fig.1)
Use a 9.5 mm (3/8”) I.D. connecting hose between
the compressor and the tool.
Drained water, etc., if flown into the tool, could
cause tool failure. Install an air filter between the
compressor and the tool.
!"$%
&
Fig. 1
