MAN
60°
40°
-
+
MAN 40° 2:30
C
START
STOPP
ON
OFF
ECO DRYER
MAN
60°
40°
-
+
MAN 40° 2:30
C
START
STOPP
ON
OFF
ECO DRYER
26
INTRODUCTION
The drying cabinet has
two automatic
programmes, one for 40 °C and one
for 60 °C.
The automatic programmes
end when
the washing is dry.
To determine when the washing is dry,
the programmes measure the tempera-
ture in the exhaust duct of the drying
cabinet and compare it with a parameter
set at the factory,
parameter
P4
for the 40 °C
programme and
parameter
P8
for the 60 °C
programme.
These are the two main parameters
to be adjusted to optimise the drying
process of the automatic programme.
If you think that the washing is not
being sufficiently dried, increase
the value of the parameter for the
relevant programme.
If you think that the washing is being
over-dried (long drying time), reduce
the value of the parameter for the
relevant programme.
Drying processes should always be opti-
mised in small steps. Begin by adjusting
the relevant parameter up or down by 1
to 2 units. Then check the result after the
next drying process and adjust further if
necessary.
PARAMETER ADJUSTMENT ETS 1700E / 1900E
Summary of Contents for ETS 1700
Page 28: ...Gematech Innovation ...
