NIMO ECO Dryer 2.0 HP, Service Manual

Page: 17 / 24

17
Service manual
Questions Action
The drying cabi-
net does not work
1. Check that the mains lead is connected to a socket.
2. Check that no fuse has blown.
3. Have you pressed the start button?
4. Is the door closed?
5. Is the water tank in position and empty?
The display shows
CHECK WATER TANK
See illistrations
1. Empty the water tank
2. Check that the cover is fitted so that the float arm protrudes out of the
opening in the lid and that the arm runs freely.
3. Check that the water tank is turned so that the float arm is inside the
box.
4. If none of the above work, the safety switch for a defective pump may
have been activated.
5. Turn off the power supply.
6. Take out the shoe rack.
7. Take out the lint filter.
8. Check whether there is water in the tray. If so:
9. Check that the drain hose is not caught or bent so that a kink has
developed or the hose runs at too steep an angle to the drain without
forming a “trap”.
10. Loosen the grille over the tray which is attached with 2x Torx 40 screws.
11. Loosen the panel holding the protector over the pump. Attached with
1x Torx 40 screw.
12. Remove the Styrofoam protector over the pump.
13. Detach the panel holding the microswitch and moisture sensor, which
is attached with 1x Torx screw and take out the float.
14. Mop up the water with a sponge or rag.
15. Refit and check that the microswitch has a small gap from the float of
1-3 mm.
16. Refit other parts.
17. Connect the power supply and test-run the cabinet, the pump should
start to pump immediately.
18. If the problem persists, the whole unit must be replaced.
9 Trouble-shooting