NIMO ECO Dryer 2.0 HP, Service Manual

Page: 16 / 24

16
Service manual
8.2 Procedure
1 Make sure that the main ON/OFF switch of the drying cabinet is in the OFF position. The
display is not lit.
2 Hold down the UP and DOWN buttons and press the main ON/OFF switch to the “ON” posi-
tion. The display lights up and shows the parameter
“P105”
and the factory preset value of
P105. The row containing the parameter concerned flashes on the display.
3 Step through to the parameter concerned by pressing the ARROW UP or DOWN button
repeatedly. If you go too far, all you need to do is to continue stepping forward until the
display shows the correct parameter.
4 When the display shows the correct parameter, e.g.
“P2072”,
press START/STOP to confirm
parameter selection. The row now flashes with the set value of the parameter.
5 Increase or reduce the parameter value using the ARROW UP or DOWN buttons.
6 To save the set value, press START/STOP.
7 To return to the operating value, press the ARROW DOWN and START/STOP.
8.3 Resetting to factory setting
1 Go to parameter display mode as described in 1-2 above.
2 Hold down the ARROW UP and ARROW DOWN buttons and press START/STOP. The factory
buttons will be saved and the display will show the most recently run programme.