16NX071900001
Cable/DSL Router User Guide
4
The rear panel contains the following features.
¾
POWER:
The Power plug is where you will connect the power adapter.
)
Note:
Please use the power adapter supplied with the 16NX071900001 Cable/DSL Router, if
you use a different adapter, it may cause damage to the Router.
¾
RESET:
Use the button to
reset the router's factory defaults. There are two ways to
reset the router's factory defaults:
•
Use
the
Factory Defaults
function on
System Tools
->
Factory Defaults
page
in the router's Web-based Utility.
•
Use the Factory Default Reset button: Press the Reset button for five seconds
and then wait for the router to reboot.
)
Note:
Ensure the router is powered on before it restarts completely.
¾
WAN:
One RJ45 port for connecting the router to a cable, DSL modem or Ethernet
¾
1/2/3/4:
Four LAN 10/100Mbps RJ45 ports for connecting the router to the local PCs
2.2 System Requirements
¾
Broadband Internet Access Service (DSL/Cable/Ethernet)
¾
One DSL/Cable modem that has an RJ45 connector (It’s not necessary if you
connect the router to Ethernet)
¾
Each PC on the LAN needs an Ethernet Adapter and an Ethernet cable with RJ45
connectors
¾
An operating system supporting the TCP/IP protocol
¾
Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator
6.0 or later
2.3 Installation Environment Requirements
¾
Not in direct sunlight or near a heater or heating vent
¾
Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on
all sides of the router
¾
Well ventilated (especially if it is in a closet)
¾
Make sure the cables and power cord are placed safely out of the way so they do
not create a tripping hazard
2.4 Connecting the Router
Before you install the router, you should connect your PC to the Internet through your
broadband service successfully. If there is any problem, please contact with your ISP for
