USER MANUAL
ENGLISH
SW 700S B
146 0594 000(4)2007-06 A
5
WARNING!
Carefully read all the instructions before performing any maintenance/repair procedure.
Take all necessary precautions to prevent hair, jewels and loose clothes from being caught by the machine
moving parts.
For machines with electronic battery charger (optional):
Before using the battery charger, ensure that frequency and voltage values, shown on the machine
serial number plate, match the electrical mains voltage.
Do not pull or carry the machine by the battery charger cable and never use the battery charger cable
as a handle. Do not close a door on the battery charger cable, or pull the battery charger cable around
sharp edges or corners. Do not run the machine on the battery charger cable. Keep the battery charger
cable away from heated surfaces.
Do not charge the batteries if the battery charger cable or the plug are damaged. If the battery charger
cable is damaged, contact Nilfi sk-Advance Service Center.
To reduce the risk of fi re, electric shock, or injury, do not leave the machine unattended when it is
plugged in. Before performing any maintenance procedure, disconnect the battery charger cable from
the electrical mains.
When the machine is equipped with lead batteries (WET), don't smoke while charging the batteries.
Do not leave the machine unattended with the key inserted in the ignition switch and the parking brake
disengaged.
Do not use the machine on slopes with a gradient exceeding the specifi cations.
Do not use the machine in excessively dusty areas.
Do not wash the machine with direct or pressurised water jets, or with corrosive substances. Do not use
compressed air to clean this type of machine, except for the fi lters (see the relevant paragraph).
While using this machine, take care not to cause damage to other people, and children especially.
Do not put any can containing fl uids on the machine.
The machine storage temperature must be between 0°C and +40°C.
The machine working temperature must be between 0°C and +40°C.
The humidity must be between 30% and 95%.
Always protect the machine against the sun, rain and bad weather, both under operation and inactivity
condition.
Do not use the machine as a means of transport, or for pushing/towing.
Do not allow the brooms to operate while the machine is stationary to avoid damaging the fl oor.
In case of fi re, possibly use a powder fi re extinguisher, not a water one.
Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
Adjust the operation speed to suit the fl oor conditions.
Do not use the machine on slopes with a gradient exceeding the specifi cations.
This machine cannot be used on roads or public streets.
Do not tamper with the machine safety guards.
Follow the routine maintenance procedures scrupulously.
Do not remove or modify the plates affi xed to the machine.
In case of machine malfunctions, ensure that these are not due to lack of maintenance. Otherwise, request
assistance from the authorised personnel or from an authorised Service Center.
If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer.
To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of
this Manual must be performed by the authorised personnel or by an authorised Service Center.
The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries,
oils, plastics, etc.), which are subject to standards that require disposal in special centres (see the
Scrapping chapter).
If the machine is used according to the instructions, the vibrations are not dangerous. The machine
vibration level is below 2.5 m/s
2
(EN 1033-1995-08).
–
–
–
•
•
•
•
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
