56041481
TURNING THE MACHINE ON
Insert the ignition key into the panel and turn it
clockwise: the display will show only zeros and after
about three seconds the battery voltage will appear.
Note
: the temporary lighting of the side brush
indicators and the short sound from the reverse
speed acoustic indicator correspond to a normal
behaviour.
Wait not less than three seconds before
restarting the machine after switch Off.
Check the charge status of the batteries on the display.
Six different data/functions s can be shown on the
display.
The six functions are described in the following table.
Notes
:
- to pass to the next function press the yellow display
button once
- the display will return automatically to the battery
voltage from every function
- data 2 and 3 will increase just using the traction
function (accelerator pedal)
- data 4, 5 and 6 will increase only if main broom is
turning AND traction function is used
- when datum 5 is displayed you can reset it just by
keeping the yellow display button pressed 5 seconds.
- If the batteries are charged enough, now it is possible
to start the job (in battery mode).
If the machine is equipped with the gasoline engine,
proceed with the start of the engine itself.
START/STOP OF THE GASOLINE ENGINE
To start the gasoline engine press the red button
shown in the figure; to stop the engine press the same
button again.
Displayed datum/function
Display
reading
1. Voltmeter:
the battery voltage is normally shown on
the display. A block function will be activated in case of
battery undervoltage: when battery voltage will be
about 20V all machine functions will stop, except
traction; in this case the display will show
0205
; proceed
then with a battery recharge (see Maintenance
paragraph). A different voltage cut –off value can be
selected for wet and gel batteries respectively.
Normally
fixed.
Flashing
when 0205
appears.
2. & 3. Hourmeter:
to read the machine working time - in
hours - press once the yellow display button. By pressing
the button a second time the working minutes will
appear. Just waiting ten seconds the display will show the
battery voltage again
Fixed
4. Total swept surface (yd
2
):
the displayed value will
increase each 1000 yd
2
Fixed
5. Daily swept surface (yd
2
):
the displayed value will
increase each 10 yd
2
Fixed
6. Productivity: sweeping rate yd
2
/h:
it depends on the
instantaneous machine working speed
Flashing
USE
8
