ENGLISH
USER MANUAL
24
146 2494 000(2)2007-02 A
SR 1100S B
TROUBLESHOOTING
Trouble
Possible cause
Remedy
The machine does not start when turning the
ignition key to "I".
The battery connector (46) is disconnected.
Connect the battery connector.
The F1 fuse in the box (51) is open.
Replace the F1 fuse.
The battery charger cable (48) is connected to
the electrical mains.
Disconnect the battery charger cable from the
electrical mains.
The machine does not move when pressing
the pedal (2).
The parking brake is engaged.
Disengage the parking brake.
When starting the machine with the ignition
key (72), the pedal (2) is pressed, or the
operator is not yet on the driver's seat.
Start the machine with the ignition key (72),
only after being on the driver's seat and
without pressing the pedal (2).
The main broom does not work.
The circuit breaker (52) is deactivated.
Reset the fuse (52) by pressing the relevant
switch.
The side brooms do not operate.
The main broom is not lowered.
Lower the main broom.
The circuit breaker (53) is deactivated.
Reset the fuse (53) by pressing the relevant
switch.
The machine operates only when stationary,
otherwise it turns off and the red warning
light (73) fl ashes.
The batteries are discharged.
Charge the batteries.
If the trouble persists, replace the batteries.
The battery autonomy is low.
The batteries are dead.
Replace the batteries.
The battery capacity is low.
Buy batteries with higher capacity (see the
Technical Data paragraph).
The dive system malfunction led (54) is
fl ashing.
The drive system is malfunctioning.
To detect the failure, refer to the Service
Manual (at any Nilfi sk-Advance Service
Center).
For further information, refer to the Service Manual, available at any Nilfi sk-Advance Service Center.
SCRAPPING
Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
Batteries
Engine oil
Polyester dust fi lter
Main and side brooms
Plastic hoses and components
Electrical and electronic components (*)
(*) Refer to the nearest Nilfi sk-Advance Center especially when scrapping electrical and electronic components.
–
–
–
–
–
–
Summary of Contents for SR 1100S B LSB*
Page 61: ...USER MANUAL ENGLISH SR 1100S B 146 2494 000 2 2007 02 A 11 WIRING DIAGRAM Continues S311411 ...
Page 99: ......
Page 100: ......
