USER MANUAL
ENGLISH
SR 1100S B
146 2494 000(2)2007-02 A
17
MAIN BROOM HEIGHT CHECK AND
ADJUSTMENT
NOTE
Brooms with harder or softer bristles are available.
This procedure is applicable to all types of brooms.
Check the main broom distance from the ground,
according to the following procedure:
Drive the machine on a level fl oor.
Keep the machine stationary, lower the main broom
and turn it on for a few seconds.
Stop and lift the main broom, then move the machine
and switch it off.
Check that the main broom print (A, Fig. 2), along its
length, is 2 to 4 cm wide.
If the print (A) is not within specifi cations, adjust the broom
height as shown in step 2.
Engage the parking brake with the pedal (3) and the lever
(4).
Turn the ignition key (72) to "0".
Open the hood (7).
Loosen the knob (A, Fig. 3) on the left side of the machine.
Turn the knob (B, Fig. 3) and remind that:
It must be screwed to lift the broom;
It must be unscrewed to lower the broom.
After the adjustment, hold the knob (B) and tighten the
knob (A).
Perform step 1 again to check that the main broom is at
the correct distance from the ground.
When the broom is too worn to be adjusted, replace it as
shown in the next paragraph.
CAUTION!
If the main broom print is excessive (larger than
4 cm), the machine regular operation is affected
and the moving or electrical parts can overheat,
thus reducing machine life.
Pay careful attention when performing the above-
mentioned checks, and always use the machine
according to the indicated conditions.
1.
•
•
•
•
2.
3.
4.
5.
6.
•
•
7.
8.
S311389
Figure 2
A
B
S311390
Figure 3
Summary of Contents for SR 1100S B LSB*
Page 61: ...USER MANUAL ENGLISH SR 1100S B 146 2494 000 2 2007 02 A 11 WIRING DIAGRAM Continues S311411 ...
Page 99: ......
Page 100: ......
