FORM NO. 56041444 / SELECTSCRUB KA-27, KA-33, KA-39 - 8
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
BRUSH PRESSURE INDICATOR
The brush pressure indicator needle reflects the amount of load on the brush drive motors. The green zone indicates a safe operating range for extended scrubbing.
The yellow zone indicates high current still within safe range for heavy stripping or scrubbing. The read zone indicates excessive current. Operating with excessive
current may cause the brush drive circuit breakers to trip, and shorten the life of the brush drive motors.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
VACUUM/SQUEEGEE LEVER
The handle on the right side at the rear of the machine is used to raise and lower the squeegee, there are three available settings. To change settings, push the
lever to the right, move up or down then pull the lever to the left to lock into desired setting. Raising the lever to the top position drops the squeegee to the floor and
provides pressure to improve pickup performance. Pushing the lever down to the bottom setting lifts the squeegee and turns the vacuum motor off. The middle position
lifts the squeegee slightly and allows the vacuum motor to continue running. This position is used when backing up during scrubbing, or when the machine is used
with the hose and wand accessory for cleaning remote areas.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
RECOVERY TANK FLOAT SWITCH
When water is detected at the full level, the vacuum motor will automatically turn off until the recovery tank is emptied.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
SOLUTION FLOW SWITCH
The Solution Flow switch is used to control the flow of solution to the floor. To start, set the switch to the desired “HI” or “LO” flow setting. To stop, snap the switch
to the center, “OFF” position.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
CIRCUIT BREAKERS
The circuit breakers, located on the back side of the machine provide protection against amperage overload on all of the machine’s motors. If a circuit breaker trips,
the button will pop out. To reset the breaker, wait a moment and press the button back in. If any of the circuit breakers trip repeatedly, have the machine examined
by the dealer from which the machine was purchased or an authorized service station.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
SOLUTION
ADDING SOLUTION
To add solution, first, remove the front tank’s lid and pour in the cleaning chemical using the correct dilution ratio. Next, fill the tank to approximately 2 inches from
the bottom of the tank opening. Water temperature must not exceed 130
°
F.
NOTE: USE NON-FOAMING CHEMICALS ONLY.
SOLUTION FILTER
This filter is located at the bottom of the tank through the opening in the front lid. This filter does not require regular cleaning; however, if something should fall into
the tank, the filter should be inspected and possibly cleaned.
OPERATION
