9 - FORM NO. 56041444 / SELECTSCRUB KA-27, KA-33, KA-39
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
EMPTYING AND RINSING THE RECOVERY TANK
To empty the recovery tank, simply remove the end of the drain hose from the hose cup at the rear of the machine (Figure 3). Place the end of the hose in a suitable
waste water drain, and pull the recovery tank’s drain valve (Figure 4). After each use, the recovery tank should be rinsed and left with the lid off, to minimize residue
buildup and odor.
OPERATION
FIGURE 3
FIGURE 4
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
RINSING THE RECOVERY TANK WITH SOLUTION
To rinse the recovery tank with the solution tank’s solution, unplug the vacuum hose from the squeegee and plug it into the solution tank’s drain valve (Figure 5).
Next, open the solution tank’s lid, then open the solution tank’s drain valve. Lower the squeegee to switch the vacuum motor on. This will rinse the recovery tank
with the solution from the solution tank. Now, you are ready to drain the recovery tank using the procedures above in “EMPTYING AND RINSING THE RECOVERY
TANK”.
FIGURE 5
