USER MANUAL
909 6754 000(2)2006-10 A
11
USE
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if they are damaged.
BEFORE MACHINE START-UP
Brush/pad-holder installation/removal
1.
Disconnect the power supply cable (3) from the electrical mains.
2.
Place the brush (A, Fig. 1) or the pad-holder (B) under the deck (14).
3.
Lower the deck on the brush/pad-holder by pressing the pedal (8).
4.
Connect the power supply cable (3) to the electrical mains.
5.
Engage the brush or pad-holder by pressing the switch (51) for a few seconds.
6.
To remove the brush/pad-holder lift the deck by pressing the pedal (8), then manually remove the brush/pad-holder from
the hub, by turning it in the opposite direction to the normal rotation direction.
S311304
Figure 1
WARNING!
On some points of the machine there are some adhesive plates indicating:
–
DANGER
–
WARNING
–
CAUTION
–
CONSULTATION
WARNING!
Do not press the switch (51) too much, otherwise the machine will start.
