Nilfisk-Advance Advolution 2710, Service Manual

Page: 16 / 60

16 - FORM NO. 56043107 - Advolution
™
2710 / UHR 70-1700
BURNISHING SYSTEM
PAD DRIVE MOTOR REMOVAL
1 Follow instructions for Pad Drive Deck Removal .
2 See Figure 2. Remove the Dust Bag (A) .
3 Tip the deck assembly over and remove the Pad Retainer (B) , pad (if installed) and the Motor Shaft Screw (C) that fastens the Pad Driver
Assembly (D) to the motor shaft.
4 Remove the Pad Driver Assembly (D) from the motor shaft. NOTE: Do not lose the motor shaft key.
5 Remove the (4) Screws (E) and the Dust Shroud (F) .
6 Remove the (4) Screws (G) that fasten the motor to the deck plate. Lift the remaining Deck Assembly (H) off the Motor (I) to complete its
removal. NOTE: Mark motor terminal location for reassembly.
7 Follow the above steps in reverse order to reinstall the Pad Drive Motor.
FIGURE 2
DUST SHROUD REMOVAL
1 See Figure 2. Remove the Dust Bag (A) .
2 Remove the Pad Retainer (B) , pad (if installed) and the Motor Shaft
Screw (C) that fastens the Pad Driver Assembly (D) to the motor
shaft.
3 Remove the Pad Driver Assembly (D) from the motor shaft. NOTE:
Do not lose the motor shaft key.
4 Remove the (4) Screws (E) and the Dust Shroud (F) .