Scru S ste
i
t Si e
Service Manual – SC8000
Maintenance an
ust ents
arnin
e ore er or in an ac ine aintenance or a ust ents a e sure t e e
s itc is o t e e is re ove ro t e ac ine an t e ar in ra e is en a e
Si e rus ilt ust ent
1. Disconnect one of the two
Rod Ends
from its
Mounting
Tab
.
2. Loosen
the
Jam Nut
.
3. Rotate
either
Rod End
to lengthen or shorten the
Rod
End Assembly
as necessary to get the correct brush
DQJOHWRWKHÁRRU
Note: The nominal factory dimension between
the Rod End stud centers is 7.5” ±.06”
[190.5 mm ±1.5 mm].
4. Make sure the threaded stud on the
Rod End
will
align with the matching hole in the
Mounting Tab
,
then tighten the
Jam Nut
.
5. Reinstall
the
Rod End
into the
Mounting Tab
.
6. Run the brush up and down to check for correct brush
DQJOHZLWKWKHÁRRU
7. Repeat steps 1 through 5 above as necessary.
Rod End
Mounting
Tab
Jam Nut
Rod
End
Mounting
Tab
Rod End
Assembly