nilco 431 ZRG, Operating Manual, Page: 9 / 23

16. Do not use the machine if the mains cable is
not in perfect condition.
2. Correct working position
1. Adjusting the control handle
17. When using or replacing the mains cable or
extension cables, do not use types that differ
from the manufacturer's original parts.
•
Undo the locking device
•
Select the working position
•
Fix the locking device
18. The connectors on mains and extension cables
must be at least splash-proof.
3. Switching on/off
19. The plug on the connecting cable must be
inserted into a socket that accords with
regulations.
Danger!
Only start the machine when the control
handle is locked.
20. Always disconnect the mains cable from the
power network before carrying out any cleaning,
servicing or maintenance work.
21. Always use suitable extension cables.
1. The built-in "dead-man's" switch prevents the
machine from being switched on when the
control handle is vertical.
22. Only connect to a power network that is fitted
with leakage current protection equipment.
23. Only persons who are familiar with the machine
and who have been instructed in the possible
hazards may operate, service or repair it.
2. Starting the Machine:
•
Possible only with tilted control handle
•
Push the switch outwards with the index
finger – press and hold
24. Remove all jewellery when working close to
electrical components.
3. Switch off
25. Only use original replacement and accessory
parts. No liability is accepted for similar parts
from other manufacturers.
•
Release the switch
•
Machine switches off
•
Bring control handle into a vertical position
26. When performing cleaning and servicing work,
ensure that authoritative regulations applicable
to the particular location regarding the correct
handling of oils, fats, acids, alkalis, fuels and
other similar agents are obeyed.
4. Using the Machine
Caution!
Take care of the mains cable
27. Observe the regulations applicable to your
location when disposing of old machines or their
components.
28. Do not clean the machine with a high-pressure
cleaner.
1. Lightly grip the handles of the control handle in
both hands
•
Start machine
1. Preparing the Machine •
Push the control handle gently downwards
= the machine runs to the left
Attaching and removing accessories.
•
Lift the control handle gently upwards = the
machine runs to the right
1.
Attaching: general accessories
•
Unplug
•
Bring control handle into a vertical position
5. Working Technique
•
Tilt machine backwards
1. Begin as far away as you can from the socket
or door
•
Fit accessory manually by turning to the left
2. Work backwards
2.
Attaching: Smoothing accessory
3. Steadily work one track forwards and back
•
Place the machine on the accessory
4. Work so that the tracks overlap by about 1/3
•
Allow the smoothing accessory to latch into
place turning anti-clockwise
6. Fitting the spray system
•
Put the control handle in the working
position
1. Undo the spray system's locking screws
2. Place it on the control handle underneath the
cable holder
•
Switch the machine on briefly
3. Point the spray nozzle towards the rear
3.
Removal: general accessories
4. Attach the cable to the lever
•
Unplug
5. Tighten the locking screws
•
Tilt machine backwards
•
Remove accessory manually by turning to
the right
7. Fitting the dust extractor
1. Mount the vacuum unit on the control handle
4.
Removal: Smoothing accessory
2. Insert the vacuum hose
3. Insert cable into the control bar
•
Control handle in the working position
4. Fit the vacuum ring •
Switch the machine on briefly
•
Smoothing accessory becomes unlatched
•
Remove machine from smoothing
accessory
9