7.3. Repeater Settings
7.3.1. Indicator Light Instructions
Introduction screen. The introductory page is displayed at the screen for 10 sec during the system check-up.
When the device completes the internal self test, it shows the standby screen. If the arrow down is displayed at the
bottom right corner, the device has detected signal reception problems. In this case press Page Down button to see
possible solutions. Resolve the issue basing on the recommendations.(see possible troubles and solutions below in
Questions & Solutions paragraph)
If the problem is resolved, the screen will display as below. No arrow means that the repeater works correctly:
LINE 1.
BS shows the level of outdoor incoming signal for the corresponding frequency band. Make sure it is as low as
possible.
Note! For the optimal functioning of the booster, the BS (input) index should be from -65 to -50 dBm. If the BS is lower
than - 65dBm, the coverage will be smaller. However, the device can work normally. If the BS is too weak, it'll be
necessary to adjust the position of the outdoor antenna by raising it as high as possible (on a pole on the rooftop) and
pointing it towards the provider's nearest base station.
Summary of Contents for LCD600-GSM+4G
Page 7: ......
