Chapter 1
Assembly
7
Ass
embly
6
Attach the epi-fluorescence cube turret and epi-fluorescence attachment (required for
epi-fluorescence microscopy).
Tool: Hex driver (2 mm across flats)
Hex wrench (3 mm across flats)
First, connect the epi-fluorescence cube turret and
epi-fluorescence attachment and then attach them on the
microscope arm.
(1) Insert the positioning pin of the epi-fluorescence
attachment while aligning it with the positioning hole
on the epi-fluorescence cube turret side, and then
tighten the connection fixing screws (x2) on the
epi-fluorescence cube turret with a hex driver.
(2) When using a motorized or intelligent
epi-fluorescence cube turret, remove the contact
cover on the contact arm beforehand.
(Contact cover is not removed for manual
epi-fluorescence cube turret.)
(3) Loosen the fixing screw on the front of the arm using
a hex driver so that the tip of the screw does not
protrude into the connecting section.
(4) Align the round dovetail and convex contact on the
bottom of the epi-fluorescence cube turret with the
round dovetail and concave contact of the arm and
slide the entire mounted attachment to the rear.
(There is no concave contact in manual
epi-fluorescence cube turret.)
(5) Tighten the fixing screw loosened in step (3).
(6) Tighten the four fixing screws on top of the
epi-fluorescence attachment.
(7) Attach the HG adapter to the bayonet mount at the
rear of the epi-fluorescence attachment and connect
the HG precentered fiber illuminator. (See the
instruction manual provided with the HG
precentered fiber illuminator.)
F. STOP
A. ST
OP
EX. ADJ
Connecting epi-fluorescence cube turret
and epi-fluorescence attachment
F. STO
P
A. ST
OP
EX. ADJ
2
1
2
3
4
5
6
Attaching and fixing epi-fluorescence cube turret
and epi-fluorescence attachment set
MODEL ECLIPSE Ni-U
NIKON CORPORATION
TOKYO, JAPAN
100–240V~
1.7A
50/60Hz
M A D
E I N
J A P
A N
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est confirme à la norme NMB-003 du Canada.
9 2 0 0
0 1
INSPECTION
EQUIPMENT
4N75
F. STOP
A. ST
OP
EX. ADJ
Attaching the HG adapter
Epi-fluorescence
cube turret
Positioning hole
Epi-fluorescence
attachment
Connection fixing screw
Epi-fluorescence
attachment
fixing screw
Fixing screw
Bayonet mount
HG adapter
HG fiber
Summary of Contents for Eclipse Ni-U
Page 2: ......
Page 8: ...Contents vi ...
Page 47: ...39 Specifications 4 Chapter 4 Specifications ...