3
Getting Started
34
Total Station DTM-302 Series Instruction Manual
Quick code measurement mode
1.
To activate Quick code measurement mode,
press
[MODE]
in the BMS.
The PT field shows the default point name.
2.
Press any numeric key (
[0]
through
[9]
) to start
measuring and recording points.
A list of the numeric keys and their assigned
feature codes appears on the right side of the
screen.
For example, when you press
[6]
, the code
assigned to 6 is selected, and the instrument
starts a measurement.
3.
If you have set the record mode to Confirm
(see Measurement settings, page 53), the
Record PT screen appears after each
measurement.
Do one of the following:
–
To record the point, press
[ENT]
.
–
To return to the BMS, press
[ESC]
.
4.
To return to the BMS from the Qcode screen, press
[MODE]
or
[ESC]
.
To assign a new feature code to a numeric key, press [
^]
or
[v]
to highlight the code
that you want to change. Then press the
Edit
softkey.
You can use the
DSP
softkey to change the values shown in the measurement box,
in the same way as you use the
[DSP]
key in the Basic Measurement Screen (BMS).
Summary of Contents for DTM-302 Series
