32
33
En
Jp
Fr
Es
Pt
Ru
Se
Nl
De
It
Dk
Pl
Hu
Cz
Fi
No
Ro
En
Jp
Fr
Es
Pt
Ru
Se
Nl
De
It
Dk
Pl
Hu
Cz
Fi
No
Ro
Others
This Nikon Laser Rangefinder is a basic rangefinder. Its results cannot be used as official evidence.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Troubleshooting/Repair
If your Nikon Laser Rangefinder should require repair, please contact your local dealer for details regarding where to
send it. Before doing so, you are advised to consult the Troubleshooting Table below.
Symptom
Check Points
Unit does not turn on — LCD fails to
illuminate
• Depress POWER button.
• Check battery insertion
• Replace the battery if necessary.
Target range cannot be obtained
• Be sure that nothing, such as your hand or finger, is blocking the laser
emission aperture and laser detector.
• Be sure that the laser emission aperture and laser detector are clean.
Clean them if necessary.
• Be sure that the target shape and condition are appropriate to reflect the
laser beam.
• Replace battery.
[- - -] (“Cannot measure”) appears
• Be sure to hold the unit steady while measuring.
• Be sure the target is within measuring range (10-550m/11-600 yards)
Closer target cannot be measured
• Be sure that nothing, such as leaves or grass, is between the Nikon Laser
Rangefinder and the target.
Target beyond a certain distance
cannot be measured
• Be sure that nothing, such as leaves or grass, is between the Nikon Laser
Rangefinder and the target.
