82
Connections : Making a SCSI Connection
✔
Caution:
Choosing a SCSI ID that has been assigned to another
device will prevent communication between the COOLPIX 300 and your
computer and could result in loss of data from your hard disk. Be sure that
the number you choose for the COOLPIX 300 is not already assigned to
another SCSI device.
Once you have chosen an SCSI ID for the COOLPIX 300, use the stylus to
choose a setting for the camera’s built-in terminator. Because the
COOLPIX 300 has only one SCSI connector, the camera will be the last
item in the SCSI chain. In most circumstances, therefore, the terminator
should be set to
ON
.
Note:
You will need to turn the camera off and then on again before any
changes to the SCSI settings will be put into effect. After turning the
camera off, wait four or five seconds before turning it on again. Once the
camera has been turned back on, the new SCSI ID will be displayed in
square brackets next to
ID
in the window shown above.
To discard any changes and return to the setup menu, press
CANCEL
.
Summary of Contents for 25040 - Coolpix 300 Digital Camera
Page 1: ......
Page 2: ......
Page 3: ...i User s Manual DIGITAL CAMERA COOLPIX 300 ...
Page 19: ...5 Before You Begin Parts of the COOLPIX 300 Parts of the COOLPIX 300 ...
