15
10-521
Other possibilities are listed below:
Program as SLAVE on internal unit 1
* 40 # serial no. bell # serial no. internal unit 1 #
Program as SLAVE on internal unit 2
* 40 # serial no. bell # serial no. internal unit 2 #
Deactivate SLAVE programming 1 & 2
* 30 # serial no. bell # 101 #
Block ring tone modification
* 30 # serial no. bell # 102 #
Block programming mode
* 30 # serial no. bell # 103 #
Undo blocking
* 30 # serial no. bell # 105 #
Back to factory defaults
* 30 # serial no. bell # 106 #
Set ring tone according to the table below
* 30 # serial no. bell # ring tone no. #
Ring tone numbers
Main external unit
Other external units
Apartment door
Internal call
0
Alpha tone 1
20
40
60
80
1
Alpha tone 2
21
41
61
81
2
Alpha tone 3
22
42
62
82
3
Alpha tone 4
23
43
63
83
4
Alpha tone 5
24
44
64
84
5
Alpha tone 6
25
45
65
85
6
Chime single
26
46
66
86
7
Chime 2 x single
27
47
67
87
8
Chime 2 x double
28
48
68 (*)
88
9
Chime 5
29
49
69
89
10 Alpha tone 3 x
30 (*)
50
70
90
11 Chime 4 x single
31
51
71
91
12 Chime 4 x double
32
52
72
92
(*) ring tone setting at delivery
Programming the bell manually
Programming the extra bell to a bell push button
1. Press the programming button on the power supply briefly to activate the programming mode (LED flashes).
2. Press the bell push button at the apartment door 2x briefly with the extra bell (floor bell push button).
3. Press the bell push button of the external unit.
4. Press the programming button of the power supply briefly to deactivate the programming mode (LED burns continuously).
Programming the extra bell in parallel with a first internal unit
1. Pick up the receiver or activate the speech connection of the internal unit.
1 2 3
2. Switch off the ring tone of the extra bell and switch it back on again within 2 sec.
3. Within 2 sec, press and hold button 1 until the red LED flashes.
4. Press briefly on button 2 on the rear of the bell (confirmation tone).
5. Replace the receiver or end the speech connection.
To program the bell with a second internal unit, repeat the steps above, but in step 4, push 3.
Modifying ring tones
1. Switch off the ring tone of the extra bell and switch it back on again within 2 sec.
2. Within 2 sec, press briefly on button 1 at the rear of the bell (red LED flashes).
3. Repeatedly press button 3 briefly to go through the ring tones for the main external unit.
4. Repeatedly press button 2 briefly to go through the ring tones for the bell at the apartment door.
5. Wait 8 seconds until the red LED stops flashing.
6. The ring tones chosen last are saved.
4. TROUBLESHOOTING
In case of problems, always first check whether the jumper is positioned correctly.
Using a multimeter, check whether the following voltages are present:
• between b and a: approx. +24V DC;
• between b and P: approx. +24V DC;
See the user manual of the internal unit for more troubleshooting tips.
EN
