www.nkrowing.com.au
1
Wiring Installation Instructions &
Troubleshooting
NIELSEN-KELLERMAN
206 Cowans Lane, Oxley Island NSW 2430
web: www.nk.com.au
E
mail: [email protected]
Phone: 02 6553 2476
F
ax: 02 6553 2544
Thank you for purchasing this StrokeCoach wiring system.
PLEASE take a moment to
review these instructions before installing the wiring harness. Your StrokeCoach system should
provide you with years of trouble-free service but we are always here to help if a problem arises.
To order parts or accessories or obtain technical support, please call 02 6553 2473 You may also
e-mail orders to [email protected] and send questions to our support representatives at
[email protected] You can also visit us on the web: www.nk.com.au
If you've never done this before, please read through all of these
installation instructions before permanently installing any part of your
StrokeCoach System.
The VHB ("Very High Bond") mounting tape used in this installation
requires 24 hours to cure to its full bond. PLEASE avoid getting it wet (in
other words, don't take your boat for a row) until fully cured. Failure to do
this risks having to re-install parts of your system.
Wherever you will be installing VHB mounting tape, make sure to use
the provided alcohol swabs to clean all oil and dust from the mounting
surfaces. Avoid touching the VHB with your fingers as the oil on your skin
decreases the bond strength.
IF you ever need to remove installed VHB, use a hair dryer to warm the
VHB thoroughly, then peel very slowly from one edge to avoid damag
ing
the surface.
