11
CHECK/ADJUSTMENT PROCEDURE: Adjusting Bevel Position
3
3.3
Adjusting Bevel Position
When the bevel of a lens is shifted from the designated position, adjust the bevel position by changing
the parameter value.
1
Check the bevel position.
1) Recall the
∅
45 built-in data, and process a
lens of SPH: approx. 1.0D in the auto bev-
eling mode.
2) Check if the bevel is produced in the
middle (5 : 5) of the edge.
If the bevel is leaning to either side, adjust it by
the following procedure.
2
Adjust the bevel position.
1) Recall the MENU screen.
Press the [MENU] button on the Layout
screen.
2) Recall the Bevel Pos. Adjustment
screen.
Press the [Bevel Pos. Adjustment] button.
3) Press the numeric button on the right of
[Bevel Position].
The numeric button turns red and the
numeric keypad appears.
/GCUWTG2QU#FLWUVOGPV
9JGGN2QU#FLWUVOGPV
5($5GVVKPI
5($#FLWUVOGPV
+FNG4QVCVKQP
&KHHGTGPVKCN
#:+5#FLWUVOGPV
$GXGN2QU#FLWUVOGPV
5K\G#FLWUVOGPV
/CKPVGPCPEG
0GVYQTM5GVVKPI
غ㧠㧡
Ǿ㧠㧡
&TGUUKPI
2TQEGUU%QWPVGT
2TQEGUU5RGGF
2CTCOGVGT5GVVKPI
㪤㪜㪥㪬
':+6
2QNKUJ$GXGN2QUKVKQP
$GXGN2QUKVKQP
':+6
$GXGN2QU#FLWUVOGPV
Summary of Contents for SE-9090 Express
Page 6: ...IV...
Page 8: ...2 REQUIREMENTS Requirements...
