- 7 -
screw nut
stopper bolt
Model
RK-3E
Motor
400W 230V 50Hz single phase
Drive System
Direct Drive DC Brushless Motor with electric speed control
Wheelhead speed
0
〜
250rpm
Speed control
Remote Foot Pedal
Wheelhead Direction
Clockwise/Counter-Clockwise
Wheelhead
Light alloy casting, diameter 350mm
Dimension
600 ×702×580mm (max)
Ship Weight
42.5kg
Troubleshooting
Problem
Problem
Problem
Problem
Problem
Note directions: Forward is clockwise; Reverse is counter clockwise
●Is the wheel plugged in to the power source?
●Is the power switch/breaker in the "on" position?
●Is the power source working correctly and supplying the correct amount of electrical current?
●Is the foot pedal cord plugged in to the wheel body?
●Is the pedal at the "0" position (heel of the foot pedal completely down)?
●Are there several wheels or other equipment/appliances on the same circuit?
(Check the breaker to see if the circuit has been overloaded.)
Wheelhead does not turn
●Is the wheel resting on a solid surface and level?
●Is there too much clay on the wheelhead?
●Is the clay totally centered?
●Are any of the adjustable legs loose?
●Has the wheelhead bolt been tightened completely?
Unusual sound coming from the wheel body
●Did the wheel stop turning when clay was added to the wheelhead?
●
The wheel could be overloaded causing the built-in breaker to open, stopping the wheel.
Remove some clay. Allow the breaker to cool.
Turn on. If the breaker opens again see your authorized Shimpo dealer.
●Did an overload cause the breaker/fuse to open at the main power source?
●Has the power cord become unplugged?
The wheelhead stops turning
The wheelhead turns in the opposite direction
●Allow the wheel to stop turning completely. forward/reverse to the desired direction.
●Loosen screw nut of stopper bolt by spanner,
twist stopper bolt until wheelhead turns,
then tighten screw nut again.
The wheelhead does not turn after pedal has been replaced.
Specifi cations
