Nidec POWERDRIVE FX 100T, Installation Manual

Page: 10 / 40

10
MECHANICAL INSTALLATION
POWERDRIVE FX Installation guide
4729 en - 2017.08 / c
2 - MECHANICAL INSTALLATION
• It is the responsibility of the owner or user of the
POWERDRIVE FX to ensure that the installation,
operation and maintenance of the drive and its options
comply with legislation relating to the safety of personnel
and equipment and with the current regulations of the
country of use.
• POWERDRIVE FX drives must be installed in an
environment free from conducting dust, corrosive
fumes, gases and fluids, and condensation (class 2
according to IEC 664.1). the drive must not be installed in
hazardous areas unless it is in an appropriate enclosure.
In this case, the installation must be approved.
• In atmospheres where condensation may form, install
a heating system (to be switched off when the drive is
operating). It is advisable to control the heating system
automatically.
• The casing of the POWERDRIVE FX is not fireproof.
If necessary, use a flameproof cabinet.
2.1 - Checks on receipt
Before installing the
POWERDRIVE FX
, check that:
- The drive has not been damaged during transport,
- The information on the nameplate is compatible with the
power supply.
2.2 - Dimensions
CAUTION:
In the cabinet, there must be a minimum distance of
100 mm between two drives, and 200 mm above and
below the drive.
2.2.1 - Surface mounting
2.2.1.1 - Ratings 33T to 50T
200
256
587
575
175
15
240*
Ø
Front view Side view
Lifting rings
Fixed with
4 M6 screws
Dimensions in mm
(*) • With MDX-I/O M2M option, add +25mm
• With MDX-ENCODER, MDX-RESOLVER, MDX-I/O Lite
or MDX-Fieldbus option, add +30mm
(the 2 option types can be combined, add +55mm)