NICHINO 650N, Operation And Maintenance Manual

Page: 5 / 8

5
(1) 每次作業前檢查離合器功效，離合器效果不佳時可調整導索或通知保修人員。
Check the performance of the clutch before operation. If the clutch performance is poor, adjust
the leading rope or call the mechanic.
(2) 操作者作業時，身體重心必須保持穩固。
When the operator is operating the machine, the center gravity of the operator shall be hold
steady.
(3) 操作者不可於刀具前進之前方操控作業，以確保人身安全(即嚴禁操作者以後退行走方式操控
作業)若須使用後退檔時，先暫時停止刀具運轉，並降低油門觀察後方及將障礙排除，確保後
方安全無慮之後，再以低速檔小心倒退(非必要時，勿使用後退檔)。
The operator should not operate the machine in front of the forward direction of the rotary blade
to protect the operator’s safety (Strictly prohibit the operator using the reverse method to
operate the machine.) If the reverse operation is required, first stop the rotary blade and
decelerate and observe the rear situation and remove any obstacles. Make sure that the rear is
safe, then reverse the gear in low speed mode with extra care (Unless it is necessary, do not use
the reverse operation.)
(4) 引擎運轉中若遇有故障或障礙需排除時，必須將引擎熄火再排除障礙，以確保人身安全。
During the engine operation, if there are any breakdown or obstacles need to remove, should turn
off the engine before the trouble shooting to protect the operator’s safety
(5) 引擎運轉中勿碰觸排氣筒 , 皮帶輪及任何轉動部位。
During the engine operation, do not touch exhaust pipe, belt wheel and any other rotary parts.
六、長期放置
Long term storage
1. 各部清洗乾淨後，檢查各部位螺絲是否有鬆動、漏油、損壞。
After clean all parts, to check if there is any looseness or oil leak or damages for all bolts of each part.
本機易生銹部分，在使用後，清洗乾淨並必須塗抹防銹油或噴漆以防生銹。
For the easily rusted parts of the machine: after using the machine, should wash clean and daub with
the antirust oil or spray paint to prevent rusting .
將油箱燃料漏乾並將引擎發動至自行熄火為止(化油器及油管內均無燃料)再將火星塞口處入機油
於汽缸內，爾後拉引擎起動拉柄，使活塞反覆運動十數次，再把火星塞鎖緊，並使活塞於汽缸內
呈壓縮狀態。
Drain away the fuel from the fuel tank and switch on the engine until the engine stop (no fuel in
carburetor and oil pipe) and infuse the engine oil into the cylinder from the spark plug cap and then
pull the engine start handle to move the piston back and forth for more than ten times, then lock the
spark plug to make the piston stay in compression condition in the cylinder.
七、 隨機配件清單
Accessories
1. 八聯耕耘刀 (一組)
8- Rotary Tillage Blade (1 set)
2. 工具袋 (一只)
Tool Bag (1 bag)