14
– English
4.2 - Commissioning
Commissioning can take place only after all testing phases have been terminated successfully (par. 4.1).
Partial or “makeshift” commissioning is strictly prohibited.
01.
Prepare and store the technical documentation for the automation for at least 10 years. This must include at least: an assembly draw-
ing of the automation, a wiring diagram, an analysis of hazards and solutions adopted, a manufacturer’s declaration of conformity of all
the devices installed (for SPY use the annexed CE declaration of conformity); a copy of the automation system instruction manual and
maintenance schedule.
02.
Post a permanent label or sign near the door detailing the release and manual manoeuvre operations (refer to the figures in “Instructions
and warnings for users of the SPY gearmotor”).
03.
Post a permanent label or sign near the gate containing this
picture (min. height 2in 1/2 - 60 mm):
04.
Using the key switch or radio transmitter or the control unit buttons, test the opening and closing of the garage door and make sure
that it moves in the intended direction.
05.
Post a label on the garage door providing at least the following data: type of automation, name and address of manufacturer (person
responsible for the “commissioning”), serial number, year of manufacture and ‘CE’ mark.
06.
Prepare the declaration of conformity of the automation system and deliver it to the owner.
07.
Give the owner the user manual (tear-out insert).
08.
Prepare and give the owner the maintenance schedule.
09.
The force adjustment is an important safety aspect and must be done with care by an expert technician. Important! - Adjustments set
to force loads higher than those allowed may cause injury to persons and animals or damage to things. Adjust the force to the minimum
available value to allow rapid and reliable detection of any obstacles.
10.
Before commissioning the gate, inform the owner in writing about the attendant residual risks.
5
5 -
PROGRAMMING
In this manual the programming procedures are explained with the use of icons and their meanings are given in the following glossary:
Symbol
Description
LED ON
LED OFF
fast flashing LED
very fast flashing LED
LED flashing LONG
LED flashing SHORT
¨
indicates the transition between states
OFF
shut off mains power
ON
supply mains power
wait
Symbol
Description
observe / check
...
s
within a few seconds
press and release the button
press and release the buttons at the same time
release the buttons
press and hold the buttons
↑
↓
select LEDs/functions
on the control unit, select the OPEN button
on the control unit, select the STOP button (SET)
on the control unit, select the CLOSE button
