4
2.1) Operating limits
Chapter 8 “Technical Characteristics” provides the data needed to determine whether the products of the SPIN line are suitable for the intend-
ed application.
The structural characteristics of the SPIN products make it suitable for use on sectional and overhead doors within the limits shown in Tables
3, 4 and 5.
The measurements in table N° 3 are guideline only and can be used as a general estimate only. The effective suitability of SPIN for automat-
ing a specific door depends on the degree of door leaf balancing, guide friction and other aspects, including occasional phenomena such as
wind pressure or the presence of ice, which could obstruct leaf movement.
To establish effective conditions, the force required to move the leaf throughout its stroke must be measured, to ensure that this value does
not exceed the “rated torque” specified in chapter “8 Technical specifications”; also, to calculate the number of cycles/hour and consecutive
cycles, the data in tables 4 and 5 must be taken into account.
The height of the door enables a calculation of the maximum number of cycles per hour and consecutive cycles, while the force required to
move the door enables a calculation of the percentage of cycle reduction; for example, if the leaf height is 2.2 m this would enable 15 cycles
per hour and 7 consecutive cycles, but if a force of 300N is required, using a SN6021 gearmotor, these would have to be reduced to 70%,
resulting therefore in 10 cycles per hour and around 5 consecutive cycles. To avoid overheating, the control unit has a limiter that is based
on the motor operation and duration of cycles, and trips when the maximum limit is exceeded.
N.B.
1Kg = 9.81N, meaning that 500N, for example, is equivalent to 51Kg.
Model:
SECTIONAL door
OVERHEAD door, non-protruding
OVERHEAD door, protruding (with accessory
(with accessory SPA5)
SPA5) or with springs (without SPA5)
Height
Width
Height
Width
Height
Width
SPIN20KCE
2.4m
4.4m
2.2m
4.2m
2.8m
4.2m
SPIN21KCE
2.4m
4.4m
2.2m
4.2m
2.8m
4.2m
SPIN30
2.4m
4.4m
2.2m
4.2m
2.8m
4.2m
SPIN40
2.4m
5.2m
2.2m
4.2m
2.8m
4.2m
SN6031 (SNA5)
2.4m
4.4m
2.2m
4.2m
2.8m
4.2m
SN6031 (SNA6)
3.4m
3.1m
3.2m
2.9m
3.5m
3.4m
SN6041 (SNA6)
3.4m
5.2m
3.2m
4.2m
3.5m
4.2m
Table No. 3: SPIN gearmotor operating limits
Leaf height
Max. no. of cycles/hour
Max. no. of consecutive cycles
Max. 2
20
10
2÷2,5
15
7
2,5÷3
12
5
3÷3,5
10
4
Table 4: limits related to leaf height
Force required to move leaf N
Cycle reduction percentage
SN6021 - SN6031
SN6041
Max. 250
100%
100%
250÷400
70%
90%
400÷500
25%
70%
500÷650
---
40%
650÷850
---
25%
Table N°5: limits in relation to force required to move door leaf
