Nice Signo, Manual

Page: 40 / 50

40
7RSURJUDPWKHDODUPWKUHVKROG
7. Set the dip switches as shown
1 2 3 4 5 6 7 8 9 10 11 12
8. Divide the number of cycles to be programmed by 1000
9. In the following table find the combination of dip switches
the sum of which is equivalent to the number you have just
calculated and set the relative dip switches to On.
Dip switch Sw1 Sw2 Sw3 Sw4 Sw5 Sw6 Sw7 Sw8
Pesi 1 2 4 8 16 32 64 128
([DPSOH
number of cycles to
be programmed = 100,000
Result after division: 100
100 = 4+ 32+64
dip switches 3, 6 and 7 set to
On
1 2 3 4 5 6 7 8 9 10 11 12
10. Execute the "Save procedure" (heading 4.4).
11. Return the dip switches to the setting indicated
1 2 3 4 5 6 7 8 9 10
11 12
After you have set the alarm threshold you can display it to be sure that the operation you have just performed
was successful.
7RGLVSOD\WKHDODUPWKUHVKROG
5. Set the dip switches as shown:
1 2 3 4 5 6 7 8 9 10 11 12
6. Set dip switch 1 to On (2,3,4,5 and 6 to Off), count the number of flashes of the OK LED and make a note
of them (if there were 10 flashes note down 0)
7. Repeat the operation with dip switches 2, 3, 4, 5 and 6
8. Now recalculate the number of cycles as shown in one of the two examples given below
Dip switch
configuration
1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6
Number
of cycles
Example:
no. 1
Number of OK
LED flashes
10 1 2 10 4 5
012,045
Example
n° 2
Number of OK
LED flashes
1 4 10 10 7 3
140,073
12. Return the dip switches to the setting indicated
1 2 3 4 5 6 7 8 9 10
11 12
Use the same procedure to display the number of cycles executed;
7RGLVSOD\WKHQXPEHURIF\FOHVH[HFXWHG
4. Set the dip switches as shown:
1 2 3 4 5 6 7 8 9 10
11 12
5. Re-count the flashes of the OK LED with dip switches 1,2,3,4,5 and 6 as shown in example 1 or 2.
1RWH
Whenever the warning threshold is programmed the value for the number of cycles executed is
automatically deleted.