29
7\SLFDOV\VWHPILJ
1 . Signo
2 . Aluminium bar
3 . Key-operated selector switch
4 . Post for selector switch
5 . Post for photocells
6 . Photocell
7 . Red rubber protective strip
8 . Safety edge or red rubber strip
9 . Flashing signal lights
10. Red reflector strips
11. Aerial
12. Flashing light
)L[LQJ
11. Embed the supplied foundation plate in a suitably sized concrete plinth. The plate must be flush with the surface
of the plinth, perfectly level, and with the exposed surface perfectly clean, taking care not to damage the thread of
the anchor fixings and providing the facility for at least one or more ducts for the routing of electrical cables.
:DUQLQJ
the plate must be parallel to the bar.
)LJ
12. Place SIGNO on the previously installed base and secure it with the supplied screws and washers.
)LJ
13. If necessary, invert the position of the spring, moving it from the right to the left. Warning: the bar will be
positioned vertically when the spring is in its relaxed position.
)LJ
14. Fit the bar with the specific bracket supplied and secure it by tightening the 4 screws.
)LJ
15. Perform the release procedure (see chapter 8 "Manual or release procedure” )
16. Bring the bar to its horizontal position and fit any optional accessories required.
17. Balance the bar by means of the spring adjuster tension rod. The bar can be considered to be properly balanced
when, positioned at an angle of 45°, it neither tends to descend nor move upwards.
)LJ
WARNING: once the
balancing procedure is terminated tighten the tension rod nuts.
18. Horizontal and vertical linear alignment can be adjusted by means of the travel limit cushioning devices
)LJ
19. Relock the barrier by performing step 5 in reverse.
20. If the SIGNO accessories are not used or only certain accessories are used, the balancing procedure can be
facilitated by fixing the spring in one of the available holes
)LJ
&RQQHFWLRQWRWKHSRZHUVXSSO\
Connect the 230V supply cable directly to the terminal.
)LJ
Secure with the specific cable clamp.
Summary of Contents for Signo
