EN
Inglese –
6
...
“
1
”
Adjust to the height "1" desired
A
B
C
D
05
04
05
04
05
04
05
04
Adjust to the height "1" desired
Adjust to the height "1" desired
Adjust to the height "1" desired
...
...
...
...
...
“
1
”
...
“
1
”
...
“
1
”
5.8 - Memorising a SECOND (third, fourth, etc.) transmitter
Caution!
To perform these procedures, you must have another transmitter already memorised.
5.8.1 - Memorising a second transmitter using “Mode I”
Caution!
– This procedure memorises the new transmitter in “Mode I”, regardless of the Mode in which the old transmitter was memorised.
Before starting the procedure, bring the awning/shutter to a point half-way along its course.
01.
(on the new transmitter)
Keep the
n
key pressed for 8 seconds and then release it (in this case the motor does not perform any movement).
02.
(on the old transmitter)
Give 3 pulses on the key
n
, provided that it is stored.
03.
(on the new transmitter)
Press the
n
key once to complete the procedure.
Caution!
– If the motor performs 6 movements, it means that its memory is full.
8
sec.
New
0,5
sec.
0,5
sec.
Old
X 3
New
01
02
03
N.B.
– When performing the procedure, you can cancel the memorisation at any time by keeping the
n
and
s
keys pressed simultaneously for 4 seconds Alternatively,
do not press any keys and wait 60 seconds for the motor to complete 6 movements.
––– Procedure 5.8.1 ––– executable only with a series transmitter Era P and Era W
01
02
6
sec.
...
PRG
PRG
03
Old
PRG
New
6
sec.
PRG
Old
1
sec.
PRG
3
2
2
2