EN
Inglese –
4
PROCEDURES
5.5 - Memorisation of the
FIRST transmitter
Warning
–
Every time the motor is powered, 2 movements are performed, if there is not at least one transmitter and the limit switch
heights in its memory.
Before starting the procedure, bring the awning/shutter to a point half-way along its course.
01.
Disconnect the power supply to the motor; wait two seconds and reconnect the power supply: the motor performs 2 movements.
02.
Keep
the
n
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
2
sec.
ON
OFF
01
02
5
sec.
3
2
5.6 - Combination of the UP and DOWN directions of the awning/shutter with their
respective keys
s
and
t
on the command device
This procedure can only be done with a “Mode I” transmitter.
Before starting the procedure, bring the awning/shutter to a point half-way along its course.
01.
Keep the
n
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02.
Keep the
s
and
t
keys pressed simultaneously and wait for the motor to perform 3 movements. Upon completion, release the keys.
03.
Keep the
s
key pressed and...
•
if the shutter starts to move in the direction UP
, keep the
s
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
•
if the shutter starts to move in the direction DOWN
, release the
s
key and keep the
t
key pressed, waiting for the motor to perform 3 movements. Upon
completion, release the key.
01
02
5
sec.
5
sec.
03
...
sec.
6
sec.
3
2
...
3
...
3
N.B.
– When performing the procedure, you can cancel the programming at any time by keeping the
n
and
t
keys pressed simultaneously for 4 seconds Alternatively,
do not press any keys and wait 60 seconds for the motor to complete 6 movements.
––– Procedure 5.6 ––– executable only with a series transmitter Era P and Era W
01
02
5
sec.
PRG
PRG
5
sec.
PRG
PRG
03
5
sec.
04
...
sec.
6
sec.
...
3
...
3
2
2
2