English –
12
A.7 - Memorisation of a climate sensor connected via radio
NOTES AND WARNINGS
• To run this procedure you need the
climate sensor
you want to memorise, chosen from the “Nice Screen” catalogue, and an
old
transmitter memorised in Mode I
(see par. 4.4.1-A).
•
When performing the procedure, you can cancel the programming at any time by holding down n and t together for 4 seconds. Alternatively, do not press any keys
and wait 60 seconds for the motor to perform 6 movements.
1
2
3
end
sensor
P1
=
10
sec
P1
OLD
...
(x
3
)
sensor
P1
(x
1
)
3
On the climate SENSOR:
hold down
the
yellow button “P1”;
release it after
10
seconds
;
On the OLD transmitter:
press
and release (
3 times
) any button.
On the climate sensor:
press and
release (
1 time
) the
yellow button
“P1”
;
count
3 movements (= sen-
sor memorised)
. If the sys-
tem makes 6 movements (=
memory locked or full, sensor
not memorised).
A
A.8 - TOTAL or PARTIAL deletion of memory
NOTES AND WARNINGS
• In order to carry out the following deletion procedures, the transmitter must be memorised in mode I.
A.8.1 - Procedure run with a memorised transmitter
1
2
3
4
PRG
(x
1
)
2
PRG
(x
1
)
2
PRG
(x
1
)
3
Press and release
the button (
1 time
);
count 2 movements.
Press and release
the button (
1 time
);
count 2 movements.
Press and release
the button (
1 time
);
count 3 movements.
A
English –
12
A.6.2.
B
- Procedure for transmitters without the “PRG” and “ESC” buttons”
•
When performing the procedure, you can cancel the programming at any time by holding down
n
and
t
together for 4 seconds. Alternatively, do not press any keys
and wait 60 seconds for the motor to perform 6 movements.
1
2
3
NEW
=
8
sec
...
...
OLD
=
5
sec
4
On the NEW transmitter:
hold down the
but-
ton you want to memorise
;
release it after
8 sec-
onds
;
On the OLD transmitter:
hold down the
button and
release it after
5
seconds
;
count 4 movements.
3
continues
Select the desired
option and program
it as follows
OLD
(x
...
)
8 OPTIONS:
1 press
= Open > Stop > Close > Stop > ...
2 presses
= Open
3 presses
= Close
4 presses
= Stop
5 presses
= Open after 10 seconds
6 presses
= Open after 20 seconds
7 presses
= Close after 10 seconds
8 presses
= Close after 20 seconds
On the OLD transmitter:
press and release the button
the number of times
indicated in the option you have chosen;
3
4
end
7
sec.
?
n
NEW
=
5
sec
...
...
3
After about 7 seconds, the motor performs a
number of
movements
equal to the number of
pulses entered.
On the NEW transmitter:
hold down
the
same button you pressed in Step 1
;
release it after
5
seconds
;
count
3 movements (= transmitter memo-
rised)
. If the system makes 6 movements (= mem-
ory locked or full, transmitter not memorised).
