Nibe PB 10, Installation And Maintenance Instructions Manual

Page: 26 / 32

24 NIBE PB 10
Miscellaneous
Pellet screw
Supply screw 1.5 m
Part no. 618 905
Installing the pellet screw in ”weekly store”
1. Check that all component parts are supplied upon delivery.
2. Place the pellet screw in the pellet store at a maximum angle of 45° from the level of the floor.
3. Install one end of the chain in the mounting eyelet on top of the drop pipe, with the supplied quick link.
4. Stretch the chain to a suitable length and secure it in the pellet store (alt.1) or in the roof (alt.2) using suitable screws
or hooks. If the chain is secured in the pellet store, a hole must be drilled through the front of the container.
5. Install the hose and hose clamps on the screw's outlet pipe and inlet pipe of the burner.
6. Make any necessary post adjustments to the screw angle and hose length. The hose should have gently sloping bends
to prevent fine particles from collecting inside it. The outlet section of the screw must be slightly recessed in relation to
the inlet side of the burner.
7. Detach the hose from the inlet pipe and run the pellet screw in the wall socket to feed in pellets. When the pellets
drop through the hose and into, for example, a bucket, run for a few more minutes to ensure an even supply.
8. Reinstall the hose on the inlet pipe and connect the pellet screw's contact to the burner.
9. Start the burner.
Maintenance instructions:
The store must be emptied of swarf/fine particles 2–4 twice a year
Pellet screw component parts 1.5 or 2.5 m:
1 x pellet screw
1 x chain 1.3 m
1 x hose ø65 mm L= 1 m
2 x quick link 4 mm
2 x hose clamp 58–75 mm
Accessories
Supply screw 2.5 m
Part no. 618 906
2
1 bar 3
0
4 T G
20
100
40 80
60
° C
0
120
T G
P
T
° C
° C
40
50
60
70
90
80
10
20
30
60
70
80
40
50
45°
Alt. 1
Alt. 2
LEK
MR
MR