Nibe FIGHTER 310P, Installation And Maintenance Instruction, Page: 11 / 36

The heat pump's air filter (63) needs to be cleaned
regularly (approximately 4 times per year) by pulling it
out and shaking it clean.
■
Set the switch (8) to “ 0 ”.
■
Open the upper front cover by pulling it out by the
lower edge, then lifting it up.
■
Pull out the filter holder (78).
■
Take out the filter and shake off any dirt.
Check that the filter is not damaged. New original
filters can be ordered from NIBE.
■
Assembly takes place in the reverse order.
The interval between cleaning operations varies and
depends on the amount of dust in the exhaust air.
Every third month a reminder for cleaning the filter is
shown in the display as “A-01”. Note that the time will
be set to zero by setting the switch to "
0 ".
Maintenance routines 9
For Home Owners
LEK
The heat pump and its ventilation ducting require some
regular maintenance when the following points should
be checked. The numbers in brackets refer to the section “Compo-
nent locations”.
Cleaning the air filter
Art.nr. 611822
2
1 bar 3
0 4
2
1
bar
3
0 4
2
1
bar
3
0 4
Transparent, blåfärgad film (ej hål).
67,5
57.25
26,3
86,3
92,7
126,8
129,8
132,8
145,2
336
41
19,2
83
90.5
111
98,6
523
10,5
Ø 52,8
53,5
135,3
130,7
15
70,5
135,3
r=4,5
37
23
9
2 st Ø 4,5, transparent, ofärgad film (ej hål).
OBS! Endast halv cirkel (radie=11)
Slits på baksidan
De 8 grårastrerade ytorna (Ø22)
skall ej förses med häftämne.
49,5
84,4
85,7
186,3
196,8
42,5
52
161
Ø 13
Ø 18,5
Hål 16 x 31
Hål 16 x 16
313,2
The building’s ventilation devices should be cleaned
regularly with a small brush to keep the correct venti-
lation.
The device settings must not be changed.
NOTE! If you take down more than one ventilation
device for cleaning, do not mix them up.
Check that the ventilation opening (84) behind the
lower front cover is not blocked. Clean if necessary.
FIGHTER 310P
Cleaning the ventilation devices
Warning to the
user!
Do not remove or adjust any
component part of this unvented water
heater: Contact the installer.
Warning to the
user!
If this unvented water heater develops
a fault, such as a flow of hot water
from the discharge pipe, switch the
heater off and contact the installer.