Nibe F2015, Installation And Maintenance Instructions Manual

Page: 9 / 44

Docking
General
F2015 can be installed in several different ways. The requisite
safety equipment must be installed in accordance with cur-
rent regulations for all docked options.
See www.nibe.eu for more docking options.
When docking with F2015, a total water volume, in the
boiler and accumulator, of at least 20 litres boiler water per
kW output on the heat pump is recommended.
Abbreviations
Shut-off valve AV
Circulation pump CP1
Included in SMO 10 Temperature sensor, flow pipe FG1
Auxiliary relay HR
Charge pump LP
Included in SMO 10 Return temperature sensor RG1
Control valve RV
Included in F2015 Particle filter SF
Shunt valve SV
Safety valve SÄV
Drain valve TV
Outside sensor UG
Heating thermostat VT
Hot water sensor VVG
F2015 docked with VVM 300 (fixed condensing)
FIGHTER 2020
VVM 300
AV
AV
SÄV
SF
RC
TV
UG
)
990
F2015 -6, -8 and -11 can be connected to VVM 300. F2015
is controlled by VVM 300. F2015 works with floating con-
densing against the heating system and prioritises hot water
charging in VVM 300.
If F2015 cannot meet the heating requirement, additional
heat is shunted in from VVM 300. If the outdoor temperat-
ure drops below the set stop temperature, VVM 300 en-
gages and takes over heating.
NOTE
To prevent interference, sensor cables and communic-
ation cables must be separated (min 20 cm) from high
voltage cables when cable routing.
7 F2015
For the Installer
Docking