aid mode
“aid mode” is a type of emergency mode. This means that
the heat pump produces heat and/or hot water even though there is
some kind of problem. This could mean that the heat pump’s compressor
is not running. In this case, the immersion heater produces heat and/or
hot water.
Caution
To select aid mode an alarm action must be selected in the
menu 5.1.4.
Caution
Selecting "aid mode” is not the same as correcting the problem
that caused the alarm. The status lamp will therefore continue
to be red.
If the alarm does not reset, contact your installer for suitable remedial
action.
NOTE
You need the product's (14 digit) serial number for servicing
and support.
You need the product's (14 digit) serial number for servicing
and support.
See page .
Troubleshooting
If the operational interference is not shown in the display the following
tips can be used:
Only additional heat
If you are unsuccessful in rectifying the fault and are unable to heat the
house, you can, whilst waiting for assistance, continue running the heat
pump in ”add. heat only” mode. This means that the heat pump only
uses the immersion heater to heat the house.
SET THE HEAT PUMP TO ADDITIONAL HEAT MODE
1.
Go to menu 4.2 op. mode.
NIBE F1255PC
BE
Chapter 4 | Disturbances in comfort
76
