
ELK 213 is an electric heater intended for heating
buildings and indirect heating of hot water. ELK 213 can
also be mounted together with a boiler, accumulator
tank or heat pump. When installing together with a heat
pump, for example, the electric heater is engaged
automatically as supplementary heating when the
heating demand is greater than the heat pump’s capa-
city.
The stainless steel electric coils and electric boiler tube
are made of acid-resistant steel (SIS 2333), which gives
a very good service life.
ELK 213 contains temperature limiter and contactors to
enable external control of the power.
ELK 213 is equipped with a time relay. Time delay is
recommended when the connected power exceeds 6
kW. The thermostats for the immersion heater and
isolator switch are operated by knobs on the control
panel.
Compatible products
Connection is different depending on which product
ELK 213 is to be used with.
These products can be connected directly to ELK 213:
• SMO 20
• SMO 40
• F1345
• F1355
These products require the accessory AXC 40:
S-series
• VVM S320
• VVM S325
• S1155
• S1255
• SMO S40
F-series
• VVM 225
• VVM 320
• VVM 325
• F1145
• F1155
• F1245
• F1255
VVM 310 requires the accessory DEH 310 .
VVM 500 requires the accessory DEH 500.
Contents
Immersion heater
1 x
Assembly
The electric heater must be installed upright (see image
below).
A free space of 800 mm in front of the water heater and
500 mm above is required to carry out servicing. If this
is not possible, detachable connections must be used.
800
500
5
Chapter 2 | General
NIBE ELK 213
2 General
Summary of Contents for ELK 213
Page 1: ...IHB EN 2036 8 031403 INSTALLER MANUAL ELECTRIC HEATER Immersion heater NIBE ELK 213 LEK...
Page 2: ......
Page 21: ......
Page 22: ......