11
We reserve the right to make technical changes
83050406cUK – Translation of the operating manual
NIBE
TM
AP-AW10
Remove the sensor head from the bracket on the
left and let the wires dangle…
pull out the insulation panels on the left and right
by pulling at the marked points (abrupt, jerky
movements facilitate the process)…
proceed by carefully routing the sensor wire
through the insulation panel on the left…
Seal the hole you created using the dummy plug
included in the extra box…
Installation of the
ventilation duct
Converting from air blower on the right to
air blower on the left
notICe.
note the air blow-out direction of the
unit.
– By default, the units ship with the air
blower on the right hand side.
Remove top front panel and set it aside on the floor.
While doing so, rotate the front panel by 180° to
protect the capillary…
“manometer”.
attentIon
pay attention to the manometer capillary.
Remove the side panel on the top left and right by
unscrewing the 2 screws on each side…
Slightly turn both side panels to the side and remove
the side panel by pushing it to the back…