Nibe AG-BU10, Manual, Page: 21 / 55

40 41
Heat pump model setup
NIBE heat pumps use 2 different frequencies: 33 kHz and 38 kHz. In order to set
your controller in the right way you should determine for the controller your heat
pump model.
951
952
NIBE other
NIBE WT10
33 kHz
38 kHz
Command SMS NIBE model Frequency used
Alarm messages setup
The Owner can change the default values of the conditions on which alarm messages
are sent. For example, SMS “9713” lowers the room temperature value at which “LOW
TEMPERATURE” SMS is sent from the default 5 °C to 3 °C.
Setup SMS
command you
send Response
SMS format NIBE AG-BU10 function you activate Default
values
971xx* SETUP
temperature treshold for
„LOW TEMPERATURE” message
5 °C
972xx* SETUP
“NO POWER” message blackout
in hours
24 h
973xx* SETUP
“SERVICE” message interval
in days
180 days
974XX* SETUP
temperature treshold for
„HIGH TEMPERATURE” message
30 °C
* xx marks the place of the numeric value
The „LOW TEMPERATURE” parameters (971) can be between 0
–
16
The “NO POWER” parameters (972) can be between 0
–
48
The “SERVICE” parameters (973) can be between 0
–
360
The „HIGH TEMPERATURE” parameters (974) can be between 17
–
40
When you set parameter 971 to 0, (e.g. you send a text message “9710”) then the
controller will not send you a “LOW TEMPERATURE” message.
When you set parameter 972 to 0, then “NO POWER” message will not be sent.
When you set parameter 973 to 0, then “SERVICE” message will not be sent.
When you set parameter 974 to 0, then “HIGH TEMPERATURE” message will not be sent.
Multiple commands
If you want to set up several parameters with one SMS, separate commands with
one of the following:
space
comma “,”
semicolon “;”
For example, the SMS „91+49550111111 92+49550222222 9513 9720”
sets the User1 and User2 numbers, specifies the heat pump model as “NIBE
other”, and determines that NO POWER message is sent immediately in case of a
power failure.
When a command in the multi-setup is incorrect, the Owner will receive an error
message. All the correct commands that precede the error command in the multi-
setup command will be activated.
Multi-setup sender will always receive SETUP report SMS from NIBE AG-BU10 to
confirm that all commands arrived to the controller. There can be spaces before
and after a command but not inside a command as this will interfere with the
code.